Customer Normal Operating Mode

The customer starts the battery save feature by doing the following:

• Insert key into ignition switch.
• Cycle the ignition switch from Off to Accessory four times without going into RUN.
• Leave the switch in the OFF position after the fourth cycle without removing the key. This puts the BCM into the learn mode.
• The customer then depresses the driver's side Power Door Lock switch in the UP direction.
• A horn chirp will tell the customer that the process has begun.
• All interior and exterior lights (if on) will be turned off.
• Key may be removed or left in at this point.
• VTSS may be armed before Sleep Mode by using the RKE or the door lock switch.

The customer can exit battery save mode by doing the following:

• Press the Driver door outside handle (this will wakeup the vehicle).
• If the door did not open, then the vehicle must be locked-press the RKE Unlock.
• Press the Driver door outside handle.
• Cycle the ignition key to RUN-this will cancel the feature.
• If the ignition is not cycled to RUN, then the BCM will re-enter Sleep Mode 30 seconds after the last door is closed.