A/C Heater Control: Installation
WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the wire harness and vacuum connectors to the back of the A/C-heater control.
- Position the A/C-heater control into the instrument panel and install the retaining screws. Tighten the screws to 2 N.m (17 in. lbs.).
- Install the instrument panel center bezel (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL CENTER BEZEL - INSTALLATION) .
- Reconnect the negative battery cable.
- Perform the A/C-Heater Control Calibration procedure (Refer to HEATING & AIR CONDITIONING/CONTROLS/A/C HEATER CONTROL - STANDARD PROCEDURE - A/C-HEATER CONTROL CALIBRATION) .