FixVault
Home › Dodge and Ram › 2005 › Viper › Repair and Diagnosis › General Information › Reset Procedures › Tire Pressure Monitor Systems › TPMS Reset Procedures › Tire Pressure Sensor Retraining

Tire Pressure Sensor Retraining

WARNING: In the following procedure, Relearn Magnet (8821) is used. Death or serious injury can occur if magnetically sensitive devices are exposed to the retraining magnet used in the TPM system. Magnets can affect pacemakers.
NOTE: To perform this procedure, a Chrysler DRB-III® scan tool must be used.
NOTE: The vehicle's tires must not have been rotated above 5 MPH (8 KM/H) in the last 2 minutes prior to programming.
  1. Connect Chrysler DRB-III® scan tool to vehicle's Data Link Connector (DLC), which is located beneath instrument panel, to right of steering column.
  2. Using scan tool, access "CHASSIS SYSTEM".
  3. Once in "CHASSIS SYSTEM", select "TIRE PRESSURE MONITOR", followed by "MISCELLANEOUS".
  4. Select appropriate function from the next screen displaying the following list options: "PROGRAM LF PRESSURE SENSOR", "PROGRAM RF PRESSURE SENSOR", "PROGRAM RR PRESSURE SENSOR", "PROGRAM LR PRESSURE SENSOR", "PROGRAM MODULE (4 SENSORS)" and "MONITOR".
  5. Place Relearn Magnet (8821) at the valve stem for that wheel as directed by the scan tool. If "PROGRAM MODULE (4 SENSORS)" function has been chosen, scan tool will direct you to left front wheel pressure sensor/transmitter first.
  6. When that wheel's pressure sensor/transmitter has been programmed, scan tool will display "PROGRAM TRANSMITTER COMPLETE" or will automatically direct you to next wheel sensor/transmitter to be programmed.
    7. NOTE: When programming the module (all 4 sensor/transmitters), magnet should be moved from wheel to wheel in a clockwise direction starting at left front wheel.
  7. Remove magnet. If programming the entire module, move the magnet to each of the remaining wheels as directed by scan tool. Each sensor/transmitter will automatically sense the presence of the magnet and begin programming.
  8. Once "PROGRAM TRANSMITTER COMPLETE" is displayed, exit program function screen. Using scan tool, verify that module programming is complete by looking at tire pressure sensor/transmitter IDs in "SENSOR DISPLAY".
About FixVault