Servo-Speed Control: Installation

Fig 1: View Of Servo, Cable Sleeve, Retaining Clip & Mounting Nuts

Courtesy of DAIMLERCHRYSLER CORP.

1. Position servo (2) to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip (3).
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install two servo-to-mounting bracket nuts (1) and tighten to 30 in. lbs. (4 N.m).
   Fig 2: Identifying Speed Control Servo Location

   Courtesy of DAIMLERCHRYSLER CORP.
5. Position servo assembly (4) to correct mounting lugs on bottom of PDC (1) and install 3 screws. Tighten 3 screws to 30 in. lbs. (4 N.m).
6. Connect vacuum line at servo.
7. Connect electrical connector at servo.
8. Connect servo cable to throttle body. Refer to INSTALLATION .
9. Connect negative battery cable to battery.
10. Before starting engine, operate accelerator pedal to check for any binding.