Speed Control Servo

Fig 1: View Of Servo, Cable Sleeve, Retaining Clip & Mounting Nuts

Courtesy of CHRYSLER LLC

Position servo (2) to mounting bracket.
Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip (3).
Insert servo mounting studs through holes in servo mounting bracket.
Install two servo-to-mounting bracket nuts (1) and tighten to 30 in. lbs. (4 N.m).

Fig 2: Locating Speed Control Servo
Courtesy of CHRYSLER LLC
Position servo assembly (4) to correct mounting lugs on bottom of PDC (1) and install 3 screws. Tighten 3 screws to 30 in. lbs. (4 N.m).
Connect vacuum line at servo.
Connect electrical connector at servo.
Connect servo cable to throttle body. Refer to Servo Cable Removal/Installation.
Connect negative battery cable to battery.
Before starting engine, operate accelerator pedal to check for any binding.