Module-Sentry Key Remote Entry

Fig 1: SKREEM Mounting

Courtesy of CHRYSLER LLC

When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order. Refer to STANDARD PROCEDURE .

1. Program the new PCM.
2. Program the new SKREEM/WCM.
3. Replace all ignition keys and program them to the new SKREEM/WCM.

1. Position the SKREEM/WCM (3) on the ignition lock housing and install the retaining screw (2).
   Fig 2: Locating Sentry Key Remote Entry Module (SKREEM) Or Wireless Control Module (WCM) Housing

   Courtesy of CHRYSLER LLC
2. Connect the SKREEM/WCM electrical connector (4).
   NOTE: On vehicles equipped with the optional Sentry Key Immobilizer System (SKIS), when the SKREEM is replaced with a new unit, a diagnostic scan tool MUST be used to initialize the new SKREEM and to program at least two Sentry Key transponders before the vehicle can be operated. See STANDARD PROCEDURE .
3. Connect the battery negative cable.