FixVault
Home › Dodge and Ram › 2008 › Caliber SXT, 2.0 B › Repair and Diagnosis › Restraints › Restraints Control Systems › Restraints System (Service Information) › Restraints - Service Information › Controller-Occupant Restraint › Removal › Controller-Occupant Restraint

Controller-Occupant Restraint

Fig 1: CENTER CONSOLE
GC0057038Courtesy of CHRYSLER LLC
  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, serious or fatal injury.
  3. Remove the floor shifter bezel (1). Refer to REMOVAL .
    Fig 2: ORC Mount Covering
    GC0053703Courtesy of CHRYSLER LLC
  4. It is necessary to lift up but not remove on the jute covered panel (1) covering the ORC (2).
    Fig 3: Replacing ORC
    GC0053704Courtesy of CHRYSLER LLC
  5. Remove the ORC mounting nuts (2).
  6. Disconnect the two ORC connectors (4).
  7. Remove ORC (3) from vehicle.
About FixVault