Diagnostic Test

1) REPLACE SIDE IMPACT SENSOR
With the scan tool, compare the left and right side impact sensor 1 configurations.

Replace the nonconforming sensor in accordance with the Service Information.

Remove any special tools or jumper wires and reconnect all previously disconnected components - except the Battery.

WARNING: To avoid serious or fatal injury, turn the ignition on, then reconnect the battery.

With the scan tool, erase all DTC in all Restraint System Modules.

Turn the Ignition off, wait 15 seconds, then turn the Ignition on.

Wait one minute before proceeding.

With the scan tool, read active ORC DTC.

Does the scan tool display: 9100-LEFT SIDE IMPACT SENSOR 1 CONFIGURATION ERROR?

Yes

WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and serious or fatal injury.

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
1. Replace the ORC in accordance with the Service information.
2. Perform *RESTRAINT SYSTEM VERIFICATION TEST .
No
1. Repair complete
  Perform *RESTRAINT SYSTEM VERIFICATION TEST .