FixVault
Home › Dodge and Ram › 2009 › Sprinter 2500, Van Cargo › Repair and Diagnosis › Restraints › Restraints Control Systems › DTCS 9424 To 9465 › 9450-Occupant Restraint Controller Connector Fault › Diagnostic Test

Diagnostic Test

  1. TEST FOR DTC 
    1. Turn the ignition on.
    2. With the scan tool, erase all DTC's.
    3. With the scan tool, read DTC's.

      Does the scan tool display this DTC?

      Repair 

        WARNING: Turn the ignition off, disconnect the battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
      • Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Check power and ground circuits. Reconnect any disconnected components and harness connectors and ensure all harness connectors are properly seated. Repair as necessary.
      • Perform *RESTRAINT VERIFICATION TEST. See DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure
About FixVault