FixVault
Home › Dodge and Ram › 2013 › Dart R/T, Standard Trans › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Electronic Control Modules (Service Information) › Module, Keyless Ignition Node › Installation › Installation

Module, Keyless Ignition Node: Installation: Installation

  1. Connect the wire harness to the keyless ignition node.
  2. Install the keyless ignition node using all four fasteners.
  3. Install the chin bezel.
  4. Install the kneeblocker/lower steering column opening trim. Refer to KNEEBLOCKER, INSTALLATION .
  5. Install the instrument panel end cap. Refer to CAP, INSTRUMENT PANEL END, INSTALLATION .
  6. Connect the negative battery cable.
About FixVault