FixVault
Home › Dodge and Ram › 2014 › Durango R/T, RWD › Repair and Diagnosis › External Pages › Different car › Section 123 (Electronic Control Modules (Service Information)) › Module, Keyless Ignition Node › Removal › Removal

Module, Keyless Ignition Node: Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the radio. Refer to RADIO, REMOVAL .
    Fig 1: Steering Column Gap Hider Bezel
    GC0173785Courtesy of CHRYSLER GROUP, LLC
  3. Using a trim stick or another suitable wide flat-bladed tool, disengage the snap clips that secure the molded hard plastic outer edges of the steering column gap hider bezel (1) to the instrument panel.
    Fig 2: Positioning Telematic Steering Column Outward And Slide Gap Hider Forward
    GC0173545Courtesy of CHRYSLER GROUP, LLC
  4. Position the telematic steering column outward and slide the gap hider forward.
    Fig 3: Keyless Ignition Node (KIN) Module Electrical Connector
    GC0173633Courtesy of CHRYSLER GROUP, LLC
  5. Reach in through the opening and disconnect the electrical connector (1) from the Keyless Ignition Node (KIN) module.
    Fig 4: KIN Retaining Tab
    GC0173625Courtesy of CHRYSLER GROUP, LLC
  6. There is a tab (1) on each side of the KIN. To remove the KIN, release each tab securing the KIN to the bezel.
About FixVault