Module, Active Damping Control: Installation: Installation

Fig 1: Active Damping Control Module, Screws & Connectors

Courtesy of CHRYSLER GROUP, LLC

1. Place the Active Damping Control Module (ADCM) (3) into position and install the four ADCM retaining screws (2). Tighten to the proper SPECIFICATIONS .
2. Install the retaining screws (2) and tighten to 9 N.m (80 in. lbs.).
3. Connect the wire harness connectors (1) to the ADCM (3). Install the inner left rear wheel well carpet. Refer to CARPET, INSTALLATION .
4. Connect the negative battery cable.
5. Perform the ADCM Verification Test. Refer to STANDARD PROCEDURE .