Module, Keyless Ignition Node: Installation: Installation

Fig 1: Keyless Ignition Node Screws

Courtesy of CHRYSLER GROUP, LLC

1. Install and tighten (1) the Keyless Ignition Node (KIN) to the kin bezel.
   Fig 2: Keyless Ignition Node Connector

   Courtesy of CHRYSLER GROUP, LLC
2. Connect the electrical connector (1) to the KIN.
   Fig 3: Steering Column Surround Bezel & Screws

   Courtesy of CHRYSLER GROUP, LLC
3. Install and tighten (1) the KIN bezel to the instrument panel. The second screw is located on the steering shroud side of the bezel.
   Fig 4: Center Bezel Retaining Clips

   Courtesy of CHRYSLER GROUP, LLC
4. Install the instrument cluster bezel (1). Refer to BEZEL, INSTRUMENT CLUSTER, INSTALLATION .
5. Connect the negative battery cable.
6. If the KIN is being replaced, perform the RFHM verification test. Refer to STANDARD PROCEDURE .