FixVault
Home › Dodge and Ram › 2016 › Challenger SXT Plus › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Electronic Control Modules (Service Information) › Module, Power Sunroof › Module Programming › Excessive Force Limitation (EFL) Calibration › Notes

Excessive Force Limitation (EFL) Calibration: Notes

NOTE:

Verify the battery is in good condition prior to performing this procedure. Do not leave the vehicle on a battery charger while performing this procedure. If the voltage at the sunroof motor/module drops below 11 volts or exceeds 15 volts at anytime while this procedure is being performed, the Excessive Force Limitation (EFL) function will not be properly calibrated.

  1. Depress the VENT push button of the sunroof switch so that the sliding glass panel travels to the fully vented position.
  2. Depress the CLOSE push button of the sunroof switch so that the sliding glass panel travels to the fully closed position.
  3. Depress the OPEN push button of the sunroof switch so that the sliding glass panel travels to the fully open position.
  4. Depress the CLOSE push button of the sunroof switch so that the sliding glass panel travels to the fully closed position.
  5. Repeat steps 2 through 5 for at least 5 complete sliding glass panel cycles (VENT, CLOSE, OPEN, CLOSE).
About FixVault