Forward Facing Camera - Calibration Procedure

WARNING: This page is about a different car, the 2014 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

The Forward Facing Camera (FFC) Calibration need to be performed when the FFC and/or windshield has been replaced. Perform the following steps:

Connect the scan tool and start the vehicle.
Navigate to the "Misc Functions" menu under the FFC and place the camera in "In Plant Mode" with the scan tool.
The screen will now prompt you to drive the vehicle for calibration. The vehicle needs to be driven at speeds of 65 km/h (40 mph) and in the straightest road condition possible. You need a lane with lines (dashed or solid) on both sides of the vehicle. This averages to roughly ten minutes of drive time, terrain permitting.
After the camera learns the calibration, the scan tool FFC view will show calibrated.
Return to the "Misc Functions" menu and exit "In Plant Mode." Service calibration DTCs should be in the stored status at this point.
Clear those DTCs.