FixVault
Home › Dodge and Ram › 2016 › Durango R/T, RWD › Repair and Diagnosis › External Pages › Different car › Section 19 (Electronic Control Modules (Service Information)) › Module, Drivetrain Control › Removal › Removal

Module, Drivetrain Control: Removal: Removal

WARNING: This page is about a different car, the 2014 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Blind Spot, Air Suspension, DTCM Modules
GC0145747Courtesy of CHRYSLER GROUP, LLC
  1. Position the left front seat to its full forward position.
  2. Disconnect and isolate the negative battery cable, refer to CABLES, BATTERY, REMOVAL for battery location and disconnect procedure.
  3. Remove the cover panel from the electronic module tub (4) to access the Drive Train Control Module (DTCM) (3).
  4. Disconnect the body wire harness connector from the module connector receptacle.
  5. Release integral latches that secures the module to the mounting bracket and slide the module upward.
  6. Remove the module from the vehicle.
About FixVault