FixVault
Home › Dodge and Ram › 2017 › Challenger SXT Plus › Repair and Diagnosis › External Pages › Different car › Section 249 (Restraints (Service Information)1500) › Module, Occupant Restraint Controller › Installation › Bracket

Module, Occupant Restraint Controller: Installation: Bracket

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

Fig 1: Screw, Nut & Adapter Bracket
GC0154615Courtesy of CHRYSLER GROUP, LLC
  1. Position the adapter bracket (1) onto the mount (4) welded onto the top of the floor panel transmission tunnel.
  2. Install and tighten the nut (3) that secures the bracket to the stud on the mount. Tighten the nut to 12 N.m (9 ft. lbs.).
  3. Install and tighten the screw (2) that secures the bracket to the mount. Tighten the screw to 10 N.m (4 ft. lbs.).
  4. Reinstall the Occupant Restraint Controller (ORC) into the vehicle. Refer to MODULE, OCCUPANT RESTRAINT CONTROLLER, INSTALLATION .
About FixVault