Section 10 (Front Axle): Installation
WARNING: This page is about a different variant/trim than selected.
- Install the front axle assembly (1) into position. Install and tighten the axle housing-to-engine bolts to the proper specification. Refer to TORQUE SPECIFICATIONS
.
- Install power steering return line to cradle by fastening clips (1).
- Install axle assembly support bracket (1) and bolts and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Install the front axle disconnect. Refer to DISCONNECT, FRONT AXLE, INSTALLATION .
- Install RH catalytic converter/exhaust pipe assembly. Refer to CONVERTER, CATALYTIC, INSTALLATION .
- Install front propeller shaft. Refer to INSTALLATION .
- Install both front half shafts. Refer to INSTALLATION
.
- Fill the axle with the specified fluid. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS . Fluid level should be at or near the bottom of the fill hole. Torque fill plug (1) to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Remove the support and lower the vehicle.