FixVault
Home › Dodge and Ram › 2019 › ProMaster 2500 › Repair and Diagnosis › Transmission › Transmission Control Systems › Automatic Transmission (Service Information) › Valve Body › Removal

Valve Body: Removal

  1. Disconnect and isolate the negative battery cable terminal from the battery post.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0122501Courtesy of CHRYSLER GROUP, LLC
  3. Remove the solenoid pack connector (2) at valve body oil pan (1).
  4. Remove the front lower closeout.
    GC0122507Courtesy of CHRYSLER GROUP, LLC
  5. If equipped remove the fasteners (1) and the Front Sound Damper Cover (2).
    GC0122509Courtesy of CHRYSLER GROUP, LLC
  6. Remove the top valve body oil pan (3) bolts.
  7. Remove the lower valve body oil pan bolts (2) and drain transmission fluid.
  8. Remove the valve body oil pan.
    GC0122511Courtesy of CHRYSLER GROUP, LLC
  9. Remove the electrical connector (1) at the valve body (2).
    GC0122788Courtesy of CHRYSLER GROUP, LLC
  10. Remove screw at detent arm (2).
  11. Remove detent arm (1).
    GC0122789Courtesy of CHRYSLER GROUP, LLC
  12. Remove the twenty one valve body to case bolts (1).
    GC0122513Courtesy of CHRYSLER GROUP, LLC
  13. Ensure the manual lever is fully forward to keep the manual valve pin (3) from binding.
  14. Pull the valve body away from the underdrive compounder assembly oil transfer tubes (2) and lift up on valve body to clear the manual valve pin past the slot in the rooster comb.
About FixVault