FixVault
Home › Dodge and Ram › 2020 › ProMaster 2500 › Repair and Diagnosis › External Pages › Different car › Section 11 (Cooling System) › Engine › Radiator, Engine Cooling › Removal › 3.6L

Radiator, Engine Cooling: Removal: 3.6L

WARNING: This page is about a different car, the 2020 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the air cleaner body. Refer to REMOVAL .
  3. Drain the cooling system. Refer to STANDARD PROCEDURE .
  4. Remove the upper radiator hose.
  5. Remove the cooling fan assembly. Refer to FAN, COOLING, REMOVAL .
  6. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  7. Remove the belly pan.
    GC0095212Courtesy of CHRYSLER GROUP, LLC
  8. Remove the lower radiator hose (1).
  9. Remove the support and lower the vehicle.
  10. Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL .
    GC0144643Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Bolts are installed with threadlocker. Use hand tools to remove the upper radiator mounting bolts.

  11. Remove the bolts (3) and the upper radiator isolator (1).
    GC0144644Courtesy of CHRYSLER GROUP, LLC
  12. Remove the lower condenser mounting bolts.
  13. Remove the bolt (2) located between the cooler lines.
  14. Using a suitable hanger, support the condenser and remove the right side upper mounting bolt.
  15. Separate the condenser assembly from the radiator.
  16. Tilt the radiator toward the engine, and remove the radiator from the vehicle.
About FixVault