FixVault
Home › Dodge and Ram › 2021 › ProMaster City Base › Repair and Diagnosis › External Pages › Different car › Section 148 (Electronic Control Modules (Service Information)) › Module, Body Control (BCM) › Removal And Installation › Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 RAM ProMaster City. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
    GC0171089Courtesy of CHRYSLER GROUP, LLC
  3. Remove the lower Body Control Module (BCM) fastener (6).
  4. Remove the fastener (7) and lower the wire harness bracket (8).
  5. Remove the fasteners (1) and lower the fuse junction block (2).
  6. Disconnect the wire harness connectors (5) from the BCM (4).
  7. Remove the upper fasteners (3) and lower the BCM slightly.
  8. Disconnect the wire harness connectors from the back side of the BCM.
  9. Remove the BCM from the vehicle.
About FixVault