Removal And Installation: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION
.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the screw (2), four bolts (3 and 4) and the right lower splash shield (1).NOTE:
Left side shown in illustration, right side similar.
- Remove the four bolts (1) holding the front of the right and left load beams to the radiator support. Do not
remove the nut (2).NOTE:
Left side shown in illustration, right side similar.
- Remove the two lower bolts (3) and the lower radiator core support (4).
- Lower the vehicle.
- Remove the two bolts (2), lift the pressurized coolant bottle (1) from the rubber grommet and reposition the coolant bottle.
- Unlock and disconnect the radiator cooling fan harness connector (4).
- Unlock and disconnect the radiator cooling fan speed control module harness connector (3).
- Disengage the wire harness retainer (2) form the fan shroud and reposition the wire harness.
- Disengage the transmission oil cooler line retainer (1) from the radiator fan shroud and reposition the oil cooler lines.NOTE:
Right side shown in illustration, left side similar.
- Press the retainers (1), lift the radiator fan shroud up off of the radiator mounts (2) and remove the fan shroud out from the bottom of the vehicle.