FixVault
Home › Dodge and Ram › 2022 › ProMaster 2500 › Repair and Diagnosis › Accessories & Equipment › Drivers Assistance Systems - ADAS › Electronic Control Modules (Service Information) › Module, Powertrain Control (Pcm) › Installation

Module, Powertrain Control (Pcm): Installation

GC0160470Courtesy of CHRYSLER GROUP, LLC
  1. If removed install the PCM bracket (2) and tighten the fasteners (3) to 18 N.m (13 ft. lbs.).
  2. Position the Powertrain Control Module (PCM) (1) to the PCM bracket (2) and tighten the three nuts (4) to 8 N.m (71 in. lbs.).
  3. Connect and lock the wire harness connectors (1) to the PCM.
  4. Install the protective cover over the PCM electrical connectors.
  5. Connect the negative battery cable.
    NOTE:

    If a new PCM is installed, it must be programed with the original Vehicle Identification Number (VIN) and mileage. If this is not done, a Diagnostic Trouble Code (DTC) may set.

    NOTE:

    If a new PCM is installed. Refer to STANDARD PROCEDURE .

  6. If a new PCM is being installed, use a scan tool to program the new PCM with the original VIN and vehicle mileage.
About FixVault