Colt, Colt 200, Summit
- Loosen throttle cable. Disconnect electrical connector from idle position switch. See Figure -Figure . Loosen lock nut at base of switch. Turn switch counterclockwise until throttle valve is fully closed.
- Connect ohmmeter between switch terminal and switch body (ground). Turn idle position switch clockwise until ohmmeter registers continuity. At this point, throttle valve begins to open.
- Turn switch 15/16 of a turn beyond contact point. Tighten lock nut at base of idle position switch, holding switch to prevent it from turning while tightening.
- Adjust throttle cable. Adjust basic idle speed. See BASIC IDLE SPEED . Adjust TPS. See THROTTLE POSITION SENSOR (TPS) .