Blower Resistor
Open glove box and remove stopper. Tilt glove box down and forward. See Figure . Disconnect blower resistor connector. With an ohmmeter, measure resistance between resistor terminals as shown in BLOWER RESISTOR SPECIFICATIONS table. If resistance is not within specification, replace blower resistor.
HEATER RESISTOR SPECIFICATIONS
| Resistance Between Terminals | Ohms Resistance |
|---|---|
| No. 3 & No. 2 | About 1.70-1.96 |
| No. 3 & No. 4 | About 0.81-0.93 |
| No. 3 & No. 1 | About 0.29-0.33 |