FixVault
Home › Eagle › 1992 › Talon Base, Standard › Repair and Diagnosis › Engine Performance › System › Engine Controls - System/Component Tests › Relays & Solenoids › Relays › Control Relay (2.0L & 2.0L Turbo)

Control Relay (2.0L & 2.0L Turbo)

  1. Control relay is located on right side of center console. Disconnect control relay connector.
  2. Using a 12-volt power source, connect positive lead to control relay terminal No. 10 and negative lead to terminal No. 8. See Fig 1. Using a voltmeter, check for voltage at terminals No. 4 and No. 5. Battery voltage should exist. Disconnect negative lead from terminal No. 8. Voltage should no longer exist at terminals No. 4 and No. 5.
  3. Connect negative lead to terminal No. 6. Ensure continuity is NOT present at terminals No. 2 and 3. Connect positive lead to terminal No. 9 and negative lead to terminal No. 6. Continuity should exist between terminals No. 2 and No. 3.
  4. Connect positive lead to terminal No. 3. If voltage exists at terminal No. 2, repair short to ground. Connect positive lead to terminal No. 3 and negative lead to terminal No. 7. If battery voltage does not exist at terminal No. 2, replace control relay.
    Fig 1: Control Relay Connector Terminal ID (2.0L & 2.0L Turbo)
    G90H06294Courtesy of CHRYSLER LLC
About FixVault