Wipers Do Not Run Continually When Washer Is Operated During DELAY Mode
WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Disconnect Black 25-pin connector from body control module located behind right front kick panel. Connect voltmeter positive lead to terminal No. 10 (Brown wire) and voltmeter negative lead to metal case of body control module.
- Turn wiper control switch to DELAY position. Depress wash switch and measure voltage. If zero volts exists, check switch relay and wiring. If 10-15 volts exists, replace body control module.