FixVault
Home › Eagle › 1995 › Vision ESi › Repair and Diagnosis › Accessories & Equipment › Wiper/Washer Systems › Testing › Motor Continues Running With Switch In Off Position

Motor Continues Running With Switch In Off Position

  1. Check wiper motor wiring harness for short between low speed motor feed terminal No. 3 (Brown/White wire) or high speed motor feed terminal No. 2 (Red/Yellow wire) and battery or ignition.
  2. Check for faulty wiper intermittent relay or HI-LO relay. Check circuit from intermittent relay cavity "B" to HI-LO relay cavity "B" (Light Green/Black wire) for short to battery or ignition.
  3. Turn ignition off. Disconnect body control module Bone 24-pin J3 connector. See Figure . Check Dark Green/Yellow wire circuit between Bone 24-pin J3 connector terminal No. 1 and intermittent wiper relay terminal "C" for short to ground.
  4. Connect voltmeter positive lead to body control module Bone 24-pin J3 connector terminal No. 16 (Dark Green/Red wire). Connect voltmeter negative lead to ground. Turn ignition on. If voltmeter reads more than zero volts, check wiper switch and wiring.
  5. Connect voltmeter positive lead to body control module Bone 24-pin J3 connector terminal No. 10 (Brown wire). If voltmeter reads 10-15 volts, check circuit for short to battery or ignition. If voltmeter reads zero volts, replace body control module.
About FixVault