FixVault
Home › Eagle › 1996 › Talon Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 83 (Body Control Computer) › Diagnostic Charts › Test VER-1A - Verification Procedure

Test VER-1A - Verification Procedure

WARNING: This page is about a different car, the 1996 Plymouth Breeze, 1996 Dodge Stratus, and 1996 Chrysler Cirrus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Reconnect all previously disconnected components and wiring. If battery or BCM has been disconnected, or any work has been performed on A/C system, A/C mode doors must be calibrated. Start engine and use scan tool to calibrate A/C mode doors. Do not allow vehicle to move during calibration. When calibration is complete, turn engine off and ignition on. Use scan tool to erase trouble codes.
  2. Turn ignition off and wait at least 5 seconds and then turn ignition on (engine off). Operate system that was malfunctioning to verify correct operation. If system operates properly, repair is complete. If system does not operate properly, go to VTSS TEST 1A.
About FixVault