Module, Transmission Control (EAB, DF1): Installation: Installation

Fig 1: Connector Area

Courtesy of CHRYSLER GROUP, LLC

Clean any debris or contaminants to the connector area.

Fig 2: Transmission Control Module
Courtesy of CHRYSLER GROUP, LLC
Use the positive locating feature on the electrical connector to orient the Transmission Control Module (TCM) prior to installation.

Fig 3: Fasteners
Courtesy of CHRYSLER GROUP, LLC
Install the TCM, tighten the fasteners to 25 N.m (18 ft. lbs.).

Fig 4: TCM Markings
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Do not turn the shaft more than 60 degrees to the marking, otherwise damage may occur.
Be sure to match the position of the TCM markings (1).

Fig 5: Transmission Control Module (TCM)
Courtesy of CHRYSLER GROUP, LLC
Connect the manual shift lever to the TCM (1), tighten the fastener to 16 N.m (12 ft. lbs.)
Connect the electrical connections to the TCM.
Install the battery tray. Refer to TRAY, BATTERY, INSTALLATION .
Reprogram the TCM. Refer to AW60T TCM PROGRAMMING PROCEDURE (CODE EAB) .