FixVault
Home › Fiat › 2013 › 500c Lounge › Repair and Diagnosis › Transmission › Transmission Control Systems › Aw60T Automatic Transaxle (Service Information) › Cable, Shift › Installation › Installation

Cable, Shift: Installation: Installation

NOTE:

Make sure the rubber grommet in the floor pan is fully seated to prevent water leaking into the passenger compartment.

Fig 1: Shifter Cable & Retaining Clip
GC0153084Courtesy of CHRYSLER GROUP, LLC
  1. Install the shifter cable to the vehicle
  2. Install the shifter cable (2) to the retaining clip (1).
    Fig 2: Shifter Cable Grommet
    GC0152805Courtesy of CHRYSLER GROUP, LLC
  3. Push the shifter cable grommet through the floor from beneath the vehicle.
  4. Lower the vehicle.
  5. Seat the rubber grommet into the floor pan. Ensure that the grommet is fully engaged to the floor pan.
  6. Install the shifter. Refer to SHIFTER, TRANSMISSION, INSTALLATION .
    Fig 3: Shift Cable, Bracket & Tabs
    GC0153005Courtesy of CHRYSLER GROUP, LLC
  7. Install the shift cable (1) to the bracket (2). Make sure the lock tab (3) on the shift cable is fully seated.
  8. Connect the shift cable (1) to the transaxle manual valve lever.
  9. Install the battery tray. Refer to TRAY, BATTERY, INSTALLATION .
  10. Adjust the shifter cable. Refer to CABLE, SHIFT, ADJUSTMENTS .
About FixVault