FixVault
Home › Fiat › 2016 › 500L Easy, Standard Trans › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Electronic Control Modules (Service Information) 500L › Module, Anti-Lock Brake System › Installation › Installation

Module, Anti-Lock Brake System: Installation: Installation

Fig 1: Identifying Integrated Control Unit Components
GC0158829Courtesy of CHRYSLER GROUP, LLC
  1. Position the Integrated Control Unit (ICU) onto the mounting pin.
  2. Install mounting fasteners (3) and tighten to the proper SPECIFICATIONS .
    Fig 2: Identifying Integrated Control Unit Components
    GC0158829Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Before installing the ABM harness connector on the ABM, be sure the seal is properly installed in the connector.

  3. Insert the ABM wiring harness connector (1) into the socket of the ABM and close the cover (5), locking the connector in place.
  4. Install the four chassis brake tubes (2) brake tubes at the ICU hydraulic control unit. Tighten the tube nuts to the proper SPECIFICATIONS .
  5. Install the primary and secondary brake tubes (4) at the ICU hydraulic control unit. Tighten the tube nuts to the proper SPECIFICATIONS .
    Fig 3: Brake Pedal Holding Tool
    GC0098418Courtesy of CHRYSLER GROUP, LLC
  6. Remove the brake pedal holding tool.
  7. Install the engine appearance cover.
  8. Reconnect the negative battery cable.
    Fig 4: Bleeding Brakes
    GC0079789Courtesy of CHRYSLER GROUP, LLC
  9. Install a scan tool to initialize the ABM and perform the following:
    1. Clear any faults.
    2. Fill the master cylinder to the proper fill level and bleed the base and ABS hydraulic systems. Refer to STANDARD PROCEDURE - BASE BRAKE BLEEDING or STANDARD PROCEDURE - ANTILOCK BRAKE SYSTEM BLEEDING .
    3. Check for leaks.
  10. Perform the Verification Test and clear any faults Refer to STANDARD PROCEDURE .
About FixVault