Radio Frequency Module (RF Hub)

• Diagnostic Code Index
• DTC Troubleshooting
  • B1026-49 Steering Column Lock-Internal Electronic Failure
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B1026-96 Steering Column Lock-Component Internal Failure
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B108B-23 Start Button Circuit A-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B108B-24 Start Button Circuit A-Signal Stuck High
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B108C-23 Start Button Circuit B-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B108C-24 Start Button Circuit B-Signal Stuck High
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10AC-13 Cruise Control Switch-Circuit Open
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10AC-23 Cruise Control Switch-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10C6-1F Exterior Trunk Antenna-Circuit Intermittent
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10C7-1F Interior Trunk Antenna-Circuit Intermittent
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10C8-1F Interior Center Antenna-Circuit Intermittent
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10C9-1F Interior Front Antenna-Circuit Intermittent
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10D1-23 Left Front Lock Button-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10D3-23 Right Front Lock Button-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10D9-87 Immobilizer Transponder-Missing Message
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10DA-51 Immobilizer Target Identifier-Not Programmed
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10DA-62 Immobilizer Target Identifier-Signal Compare Failure
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10E7-11 Ignition On Relay-Circuit Short To Ground
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10E7-12 Ignition On Relay-Circuit Short To Battery
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10E7-16 Ignition On Relay-Circuit Voltage Below Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B10E7-17 Ignition On Relay-Circuit Voltage Above Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B11FD-1F Left Front Exterior Antenna-Circuit Intermittent
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B1210-1F Right Front Exterior Antenna-Circuit Intermittent
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B124C-56 Turn Indicator Stalk Switch Pack-Invalid-Incompatible Configuration
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13C3-04 Antenna Control Module-System Internal Failures
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13C3-09 Antenna Control Module-Component Failures
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13C3-16 Antenna Control Module-Circuit Voltage Below Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13C3-29 Antenna Control Module-Signal Signal Invalid
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13D3-05 Immobilizer Transmitter-System Programming Failures
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13D3-16 Immobilizer Transmitter-Circuit Voltage Below Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13D3-4A Immobilizer Transmitter-Incorrect Component Installed
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13D3-51 Immobilizer Transmitter-Not Programmed
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13D3-94 Immobilizer Transmitter-Unexpected Operation
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13D3-97 Immobilizer Transmitter-Component Or System Operation Obstructed Or Blocked
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B13D4-00 Immobilizer Transmitter Less Than Minimum Programmed-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • B1C53-13 Front Wiper Intermittent Data-Circuit Open
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C0040-23 Brake Pedal Switch A-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C0040-24 Brake Pedal Switch A-Signal Stuck High
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C0051-2F Steering Wheel Position Sensor-Signal Erratic
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C0051-95 Steering Wheel Position Sensor-Incorrect Assembly
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C0052-14 Steering Wheel Position Sensor Signal A-Circuit Short To Ground Or Open
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C0052-2F Steering Wheel Position Sensor Signal A-Signal Erratic
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C0053-14 Steering Wheel Position Sensor Signal B-Circuit Short To Ground Or Open
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C0053-2F Steering Wheel Position Sensor Signal B-Signal Erratic
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C2003-13 Steering Wheel Switch Left Module-Circuit Open
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0560-16 System Voltage-Circuit Voltage Below Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0615-11 Starter Relay Circuit-Circuit Short To Ground
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0615-12 Starter Relay Circuit-Circuit Short To Battery
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0615-13 Starter Relay Circuit-Circuit Open
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0615-16 Starter Relay Circuit-Circuit Voltage Below Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0616-23 Starter Relay Circuit Low-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0616-24 Starter Relay Circuit Low-Signal Stuck High
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0616-29 Starter Relay Circuit Low-Signal Invalid
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P081C-23 Park Input Circuit-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P081C-24 Park Input Circuit-Signal Stuck High
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P081D-29 Neutral Input Circuit-Signal Invalid
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0830-23 Clutch Pedal Switch A Circuit-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0850-23 Park-Neutral Switch Input Circuit-Signal Stuck Low
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0850-24 Park-Neutral Switch Input Circuit-Signal Stuck High
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P0930-71 Gear Shift Lock Solenoid-Actuator Circuit A Low-Actuator Stuck
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P1708-24 Clutch Switch Circuit-Signal Stuck High
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P1708-29 Clutch Switch Circuit-Signal Signal Invalid
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • P1794-16 Battery Voltage Circuit-Circuit Voltage Below Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0001-88 High Speed Can Communication Bus-Bus Off
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0028-87 Vehicle Communication Bus A-Missing Message
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0100-00 Lost Communication With ECM-Pcm A-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0100-87 Lost Communication With ECM-Pcm A-Missing Message
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0101-00 Lost Communication With TCM-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0121-00 Lost Communication With Anti-Lock Brake System-Abs-Control Module-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0121-87 Lost Communication With Anti-Lock Brake System-Abs-Control Module-Missing Message
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0131-00 Lost Communication With Power Steering Control Module-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0140-00 Lost Communication With Body Control Module-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0146-00 Lost Communication With Gateway A-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0151-00 Lost Communication With Restraints Control Module-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0155-00 Lost Communication With Instrument Panel Cluster-IPC-Control Module-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U0447-86 Invalid Data Received From Gateway A-Signal Invalid
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U201F-11 External Receiver-Circuit Short To Ground
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U201F-12 External Receiver-Circuit Short To Battery
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U2100-00 Initial Configuration Not Complete-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U2300-00 Central Configuration-No Sub Type Information
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U3000-01 Control Module-General Electrical Failure
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U3000-49 Control Module-Internal Electronic Failure
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U3000-96 Control Module-Component Internal Failure
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U3003-16 Battery Voltage-Circuit Voltage Below Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U3004-11 Accessory Power Relay-Circuit Short To Ground
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U3004-12 Accessory Power Relay-Circuit Short To Battery
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U3004-16 Accessory Power Relay-Circuit Voltage Below Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • U3004-17 Accessory Power Relay-Circuit Voltage Above Threshold
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test