Flash: Powertrain Control Module (Pcm) Updates (18-018-21)

Publication date: 2021-02-10
Reference number: 18-018-21

FLASH: POWERTRAIN CONTROL MODULE (PCM) UPDATES

TECHNICAL SERVICE BULLETIN

Reference Number(s): 18-018-21, Date of Issue: February 10, 2021

CHRYSLER:	2020 FIAT 500X (FD)
GROUP:	18 - Vehicle Performance

OVERVIEW

This bulletin involves reprogramming the PCM with the latest available software.

MODELS

MODELS CHART

2020

(FD)

FIAT 500X

NOTE: This bulletin applies to vehicles within the following markets/countries: North America.

NOTE: This bulletin applies to vehicles equipped with a 1.3L I4 Turbo Multi-air DI Engine W/ESS (Sales Code EYF).

SYMPTOM/CONDITION

Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) have been set:

P2110 - Electronic Throttle Control System Bank 1 - Forced Limited RPM.
P2173 - High Airflow/Vacuum Leak Detected (Slow Accumulation).
P0607 - Control Module Performance.

DIAGNOSIS

Using a Scan Tool (wiTECH) with the appropriate Diagnostic Procedures available in DealerCONNECT/Service Library, verify all related systems are functioning as designed. If DTCs or symptom conditions, other than the one listed are present, record the issues on the repair order and repair as necessary before proceeding further with this bulletin.

If the customer describes the symptom/condition listed above or if the technician finds the DTC, perform the Repair Procedure.

REPAIR PROCEDURE

NOTE: Install a battery charger to ensure battery voltage does not drop below 13.2 volts. Do not allow the charging voltage to climb above 13.5 volts during the flash process.

NOTE: If this flash process is interrupted/aborted, the flash should be restarted.

Reprogram the PCM with the latest software. Detailed instructions for flashing control modules using the wiTECH Diagnostic Application are available by selecting the application's "HELP" tab.
Clear all DTCs that may have been set in any module due to reprogramming. The wiTECH application will automatically present all DTCs after the flash and allow them to be cleared.

POLICY

Reimbursable within the provisions of the warranty.

TIME ALLOWANCE

TIME ALLOWANCE CHART

Labor Operation No:	Description	Skill Category	Amount
18-19-06-BG	Module, Powertrain Control (PCM) - Reprogram (0 - Introduction)	1 - Engine Repair and Performance	0.3 Hrs.

NOTE: The expected completion time for the flash download portion of this procedure is approximately 5 minutes. Actual flash download times may be affected by vehicle connection and network capabilities.

FAILURE CODE

The dealer must use failure code CC with this Service Bulletin.

If the customer's concern matches the SYMPTOM/CONDITION identified in the Service Bulletin, failure code CC is to be used.
When utilizing this failure code, the 3C's (customer's concern, cause and correction) must be provided for processing Service Bulletin flash/reprogramming conditions.

FAILURE CODE CHART

CC	Customer Concern