FixVault
Home › Fiat › 2023 › 500X Pop › Repair and Diagnosis › Transmission › Automatic Trans › Cooling System › Engine › Fan, Cooling › Removal And Installation › Installation

Removal And Installation: Installation

  1. Install the cooling fan and engage the retaining clips.
  2. Install and securely tighten the fan to the radiator bolts.
  3. Install the lower radiator support brackets and securely tighten the bolts.
  4. Engage the engine cooling system supply pipe to the retainers on the fan shroud.
  5. Connect the cooling fan wire harness connector.
  6. Install the lower duct and securely tighten the bolts.
  7. Engage the automatic transmission oil pipes retaining clip.
  8. Install the front bumper reinforcement. Refer to REINFORCEMENT, BUMPER, FRONT, REMOVAL AND INSTALLATION .
  9. Install the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION .
  10. Install the belly pan. Refer to BELLY PAN, REMOVAL AND INSTALLATION or BELLY PAN, SIDE, REMOVAL AND INSTALLATION .
  11. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
About FixVault