MOTORCRAFT DURA-Spark II Electronic Ignition System: Overhaul: Disassembly

Remove distributor cap and rotor. Disconnect distributor wiring harness connector. Using a small gear puller or 2 screwdrivers, carefully pry armature (reluctor) from sleeve and plate assembly. Remove spring pin.
NOTE: When removing armature with screwdrivers, lever against lower plate only (not upper plate). Lower plate is supported by base casting.
Remove snap ring, washer and wave washer. Remove ground screw and stator (pick-up coil) assembly. Remove vacuum diaphragm attaching screws and remove unit by tilting downward to disengage link from the advance plate.