FixVault
Home › Ford › 1983 › Ranger 2.2 P › Repair and Diagnosis › Engine Performance › Ignition System › Ignition System - DURA-Spark II › Testing › Pick-Up Coil & Distributor Wiring Harness Check

Pick-Up Coil & Distributor Wiring Harness Check

  1. Disconnect control module 4-wire connector, and inspect for dirt, corrosion or damage. Connect ohmmeter leads to harness connector terminals that mate with Orange and Purple control module wires.
  2. Resistance should be 400-1300 ohms. If so, proceed to "Control Module to Distributor Wiring Harness Check". If resistance is not to specifications, proceed to "Pick-Up Coil Resistance Check".
About FixVault