Ignition Timing
- Turn off all lights and accessories. Set parking brake and place transmission in Neutral (M/T) or Drive (A/T). Ensure A/C and heater are off. Connect timing light. Disconnect the single wire in-line spout connector or remove shorting bar from the double wire spout connector (located in wiring harness to distributor).
- Start engine and warm to normal operating temperature. With engine at idle, check timing and adjust if necessary. See IGNITION TIMING SPECIFICATIONS
table. Turn engine off and reconnect spout connector or reinstall shorting bar.
- Restart engine. Check timing advance to verify distributor is advancing properly. Remove test equipment.
IGNITION TIMING SPECIFICATIONS
| Application |
Degrees BTDC @ RPM |
| All Models |
10@Idle |