Axle Beam: Remove & Replace
WARNING: This page is about the Bronco 4.9 Y, Automatic, which is a different variant/trim than selected.
DOES NOT include alignment.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Front,Both | 6.6 | 5.8 | B | |
| Front,Left | 4.2 | 3.7 | B | |
| Front,Right Side | 3.3 | 2.9 | B | |
| Additional Procedure: AXLE BEAM: Remove & Replace: | ||||
| Where Stabilizer Bar interferes add | 0.1 | 0.1 | B | |
| Combination Procedure: BALL JOINT: Remove & Replace: | ||||
| One Side | 0.2 | B | ||
| Combination Procedure: PIVOT PIN BEARING: Remove & Replace: | ||||
| One Side | 0.2 | B | ||