Test DN: Step 96

96) EVR Solenoid Check Using Continuous Monitor Mode (Wiggle Test), observe VOM or diagnostic tester for fault indication. Grasp harness close to EVR solenoid connector and wiggle, shake, or bend a small section of harness while working toward ECA. Inspect connectors and terminals for obvious damage. If fault is indicated, isolate fault and repair as necessary. Clear codes and repeat QUICK TEST. If no fault is indicated, fault cannot be duplicated at this time. Clear codes and repeat QUICK TEST.

NOTE: There is a break in the step numbering sequence at this point, skipping from step 96) to step 98). Break is due to previous chart references to these testing procedures. No test procedures have been omitted.