Test KD: Step 10

10) Check CANP Circuit For Short to Power Turn key off and wait 10 seconds. Disconnect CANP solenoid. Install breakout box, leaving ECA disconnected. Set DVOM on 200-k/ohm scale and disconnect CANP solenoid. Measure resistance between test pin No. 31 and test pins No. 37 and 57. If all reading are 10 k/ohms or more, remove breakout box. Replace ECA and repeat QUICK TEST. If any reading is less than 10 k/ohms, repair short to power, remove breakout box and reconnect components. Repeat QUICK TEST. If any resistance is greater than 10 k/ohms, replace ECA. Remove breakout box and reconnect components. Repeat QUICK TEST.

NOTE: There is a break in the step numbering sequence at this point, skipping from step 10) to step 15). Break is due to previous chart references to these testing procedures. No test procedures have been omitted.