FixVault
Home › Ford › 1990 › Probe GL, Automatic › Repair and Diagnosis › Electrical › Gauges › Instrument Panel - Electronic › Testing › Speedometer Signal Check 1

Speedometer Signal Check 1

  1. Place test light between a 12-volt source and Green/Red wire at instrument cluster 18-pin connector. Instrument cluster 18-pin connector is located behind instrument cluster. See Figure .
  2. Drive vehicle between 0-5 MPH. If test light glows, replace instrument cluster. If test light does not glow and vehicle has an automatic transmission, go to SPEEDOMETER SIGNAL CHECK 2  .
About FixVault