Test 48, Check C1, C2 & C3 At Coil Pack

Turn key off, and connect ECA. Set DVOM to 20-volt AC scale. Crank engine, and measure voltage between breakout box pins No. J7 (BAT -) and J3 (C1), J7 and J6 (C2) and J7 and J10 (C3). If any settled voltage is less than 0.2 volt, replace coil pack. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes. If all settled voltage readings are greater than 0.2 volt, go to TEST 50.