FixVault
Home › Ford › 1991 › Probe GL, Standard › Repair and Diagnosis › Heating, Ventilation & A/C (HVAC) › A/C Compressor Oil Checking › Oil Checking › NIPPONDENSO 10P13 Compressor

NIPPONDENSO 10P13 Compressor

  1. Start and run engine at high idle with A/C on for 15 minutes. Stop engine and slowly discharge system using approved refrigerant recovery/recycling equipment. Remove A/C compressor. Drain compressor oil. Measure amount drained and discard oil.
  2. If amount drained is between 3 and 5 ounces, add drained amount of new refrigerant oil into compressor through suction port. If amount drained is less than 3 ounces, add 3 ounces.
  3. If amount drained is more than 5 ounces, add 5 ounces. Use new "O" rings on refrigerant lines. Install A/C compressor. Evacuate and recharge system. Perform leak test.
About FixVault