FixVault
Home › Ford › 1992 › Probe GL, Automatic › Repair and Diagnosis › Electrical › Gauges › Instrument Panel - Electronic › Testing › Hazard Warning Switch

Hazard Warning Switch

  1. Ensure HAZARD fuse is okay. Replace if necessary. If fuse blows, repair short in Brown wire to flasher unit. If fuse is okay, go to next step.
  2. Remove flasher unit, located at relay module at left side of dash. Check for battery voltage at Brown wire at flasher unit connector. If battery voltage exists, go to step 3). If battery voltage is not present, repair Brown wire from fuse panel.
  3. Measure resistance between Black wire at flasher unit and ground. If resistance is less than 5 ohms, go to step 4). If resistance is at least 5 ohms, repair Black wire to ground.
  4. Ground Green/Red wire at flasher unit. If hazard lights do not flash, go to step 5). If hazard lights flash, go to step 6).
  5. Disconnect flasher unit. Measure resistance between Green/Red wire at flasher unit and Green/Red wire at hazard switch. If resistance is less than 5 ohms, replace flasher unit. If resistance is at least 5 ohms, repair Green/Red wire.
  6. Engage flasher switch. Ground Black wire at hazard switch. If hazard lights flash, repair Black wire to ground. If hazard lights do not flash, replace flasher unit.
About FixVault