Intermittent Simulation

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1993 Ford Ranger, 1993 Ford RV Cutaway, 1993 Ford Pickup, 1993 Ford F-Super Duty, and 1993 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

To reproduce the conditions creating an intermittent fault, use the following methods:

Lightly vibrate component.
Heat component.
Wiggle or bend wiring harness.
Spray component with water.
Remove/apply vacuum source.

Monitor circuit/component voltage or resistance while simulating intermittent. If engine is running, monitor for self-diagnostic codes. See appropriate TESTS W/CODES article in the ENGINE PERFORMANCE section. Use test results to identify a faulty component or circuit.

NOTE: For test equipment connection and continuous monitor mode test operation, see TESTS W/CODES article in the ENGINE PERFORMANCE section.