Ignition Switch
- Test for continuity between specified terminals with switch in each position. See Fig 1
. If continuity is not as specified, or is poor in any switch position, replace ignition switch.
Courtesy of FORD MOTOR CO.
- Continuity should exist between terminals B2 and START with switch in START position. Continuity should not exist with switch in any other position.
- Continuity should exist between terminals B1 and ACC with switch in ACC or RUN position. Continuity should not exist with switch in any other position.
- Continuity should exist between terminals B1 and IG1 with switch in START or RUN position. Continuity should not exist with switch in any other position.
- Continuity should exist between terminals B2 and IG2 with switch in RUN position. Continuity should not exist with switch in any other position.
- Continuity should not exist between terminals B1 and B2 with switch in any position.
- Continuity should exist between terminals K1 and K2 with key in lock. Continuity should not exist with key removed.