Retrieve/Clear Continuous DTCS

Turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps:

• Select VEHICLE & ENGINE SELECTION menu.
• Select NEW VEHICLE, YEAR & MODEL.
• Select DIAGNOSTIC DATA LINK.
• Select PCM - POWERTRAIN CONTROL MODULE.
• Select DIAGNOSTIC TEST MODE.
• Select RETRIEVE/CLEAR CONTINUOUS DTCs.
• Turn ignition on.
• Follow operating instructions from scan tool menu.
• Record DTCs and perform appropriate pinpoint test. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION .
• Continuous Memory DTCs must be cleared after servicing EEC-IV system. See CLEARING DTCS  under SELF-DIAGNOSTIC SYSTEM.
• After test, cycle ignition off before running other tests or driving vehicle.