Removal & Installation (Windstar)
Disconnect negative battery cable. Remove any Remove cowl top vent panel. See Fig 1. Loosen Powertrain Control Module (PCM) connector retaining bolt (if equipped). Unplug harness connector from PCM. Remove 2 PCM mounting nuts. Remove PCM cover and PCM. To install, reverse removal procedure.
PCM LOCATIONS
| Model | Location |
|---|---|
| Aerostar | Near Master Cylinder |
| Windstar | Cowl Area (Passenger side) |
| Villager | Behind Center Heating Duct (Next To Instrument Panel Support) |