Door Lock Relay
- Remove relay connectors located at lower right side of instrument panel reinforcement. Using ohmmeter, measure resistance between relay terminals No. 2 and 3, and terminals No. 2 and 5. Resistance should be 5 ohms or less. See Fig 1.
- Apply battery voltage to relay terminal No. 1 and ground terminal No. 3. Measure resistance between terminals No. 2 and 4. Resistance should be 5 ohms or less.
- Apply battery voltage to relay terminal No. 6 and ground terminal No. 3. Measure resistance between terminals No. 4 and 5. Resistance should be 5 ohms or less. If relay does not test as specified, replace relay.
Courtesy of FORD MOTOR CO.